DASKEREL published · Year 11 · academic review pending

Biology GCSE

Original DASKEREL teaching informed by an attributed Oak unit sequence. This resource remains subject to qualified academic review. Check your examination board and tier before using it for exam preparation.

Year 11 · Original DASKEREL extended lesson · Academic review pending

Investigating factors that limit photosynthesis

Allow up to 60 minutes for reading, practice and review · Source route: Oak AQA Biology Foundation; academic review required

DASKEREL wrote this resource using the Oak National Academy unit sequence as a curriculum reference. It is an extended lesson, not a complete unit or an exam-board-approved course. Academic review remains pending.

You will learn to

  • Explain how light, carbon dioxide and temperature can limit the rate of photosynthesis.
  • Plan a fair pondweed investigation with controls and repeat measurements.
  • Calculate a rate and evaluate what the measurement can and cannot show.

Key terms: photosynthesis · limiting factor · light intensity · rate · control variable · reliability · validity

Teaching sequence

Check these ideas before you begin:

  • Recall the reactants and products of photosynthesis and the role of chlorophyll.
  • Calculate a mean and convert seconds into minutes.
  1. 1. Retrieve and predict · about 8 minutes

    Teach or study: Ask learners to distinguish light energy from the chemical reactants before predicting a rate graph.

    Try: Write the photosynthesis equation and predict the low-light trend.

  2. 2. Model limiting factors · about 12 minutes

    Teach or study: Sketch a rising then levelling graph and challenge learners to name an alternative limiting factor.

    Try: Annotate each section of the graph with a justified explanation.

  3. 3. Design a fair test · about 14 minutes

    Teach or study: Discuss lamp distance, settling time and temperature drift; keep equipment handling teacher supervised.

    Try: Identify the independent, dependent and three control variables.

  4. 4. Calculate and evaluate · about 18 minutes

    Teach or study: Model bubble-rate conversions and then ask why bubbles are an imperfect proxy for oxygen volume.

    Try: Complete the worked and independent calculations with units.

  5. 5. Exit and revisit · about 8 minutes

    Teach or study: Use the exit answers to distinguish a supported data trend from an unsupported causal claim.

    Try: Answer both exit prompts and correct one overconfident conclusion.

Learn the idea

Photosynthesis transfers light energy into chemical energy stored in glucose. Its word equation is carbon dioxide + water → glucose + oxygen. The balanced symbol equation is 6CO₂ + 6H₂O → C₆H₁₂O₆ + 6O₂. Light supplies energy; it is not a chemical reactant. Chlorophyll in chloroplasts absorbs light. A plant may have enough water and carbon dioxide yet photosynthesise slowly in dim light because the available light energy limits the process. A rate describes how much change occurs in a stated time, so every rate claim needs a measured quantity and a time interval.

A factor is limiting when changing it could increase the rate; more than one factor may constrain the process. At low light intensity, increasing light usually increases rate; eventually the graph may level because another factor, such as carbon dioxide concentration or temperature, has become limiting. A flat part does not mean light has stopped reaching the plant. Temperature matters because photosynthesis includes enzyme-controlled reactions. Low temperature slows those reactions; a temperature far above the optimum may reduce the rate as enzymes lose their useful shape. Do not promise that rate always rises with temperature: describe the range and evidence being considered.

One school investigation changes the distance between a low-voltage lamp and a piece of pondweed and estimates oxygen production. Keep the plant species, length of cut shoot, carbon dioxide supply, counting time and temperature as constant as practicable. Changing lamp distance is a proxy for changing light intensity, but it can also heat the water. A teacher should manage electrical equipment and water safely. Allow the plant to settle at each distance before measuring. Repeat each position, calculate a mean and note unusual readings rather than silently deleting them. Use equal counting intervals, such as one minute, so rates are comparable.

Counting oxygen bubbles is simple but is an imperfect measure: bubbles vary in size, some oxygen dissolves in water, and a very rapid stream may be hard to count. A gas-volume collection method can give a more direct measure if suitable apparatus is available, but it too needs careful reading and leak checks. A fair test controls other variables; a reliable result is repeatable; a valid inference is about the intended factor. These words are related but not interchangeable. If temperature drifted between lamp distances, the pattern cannot confidently be attributed to light alone.

Suppose a shoot produces 24 bubbles in 120 seconds. Its observed bubble rate is 24 ÷ 2 = 12 bubbles per minute, or 24 ÷ 120 = 0.20 bubbles per second. The two numerical answers express the same observation in different units. A second trial at 60 bubbles in 120 seconds is 30 bubbles per minute, but it does not prove oxygen volume was 2.5 times greater because bubble volumes may differ. When drawing a conclusion, state the measured trend, give a comparison with units, describe the controlled conditions and give a limitation. Link the interpretation to limiting factors only where the data support it.

Worked example

A pondweed shoot produces 18, 21 and 24 bubbles in separate one-minute trials at one lamp distance. Find the mean observed rate and state one limitation.

  1. Add the counts: 18 + 21 + 24 = 63 bubbles.
  2. Divide by three equal one-minute trials: 63 ÷ 3 = 21 bubbles per minute.
  3. State that bubble count estimates oxygen production but individual bubble volumes may differ.
  4. Keep temperature and the same shoot conditions controlled before comparing another distance.

The mean observed rate is 21 bubbles per minute. It is an estimate based on bubble counts, not a direct oxygen-volume measurement.

Try together

At a second distance, the same shoot gives 52 and 48 bubbles in two 120-second trials. Calculate the mean rate per minute and give one reason to repeat again.

  • Find the mean count for a 120-second interval first.
  • Convert the two-minute count to a one-minute rate.
Show guided answer

The mean is 50 bubbles in 120 seconds, or 25 bubbles per minute. A further repeat helps assess variation and spot an anomalous count.

Practise independently

  1. Name two factors other than light that may limit photosynthesis.
    Show answer and reasoning for question 1

    Carbon dioxide concentration and temperature. Each may constrain a different part of the process even when more light is available.

  2. A shoot produces 36 bubbles in three minutes. Find the observed rate.
    Show answer and reasoning for question 2

    12 bubbles per minute. Divide the count by the three-minute observation time and include units.

  3. State the independent variable when a lamp is moved between positions.
    Show answer and reasoning for question 3

    Distance from lamp to shoot, used as a proxy for light intensity. The distance is deliberately changed; the rate of bubble release is measured.

  4. Give two variables that should remain controlled in a lamp-distance investigation.
    Show answer and reasoning for question 4

    Temperature and carbon dioxide supply, for example. Their changes could alter photosynthesis independently of the changed lamp distance.

  5. Explain why counting bubbles does not measure oxygen volume exactly.
    Show answer and reasoning for question 5

    Bubbles can have different volumes and some oxygen dissolves. A count treats unequal bubbles as equal and misses dissolved oxygen.

  6. A graph levels at high light. Does this prove carbon dioxide is limiting?
    Show answer and reasoning for question 6

    No; carbon dioxide is one possible limiting factor. Temperature or another condition could also limit the rate; test the hypothesis.

DASKEREL exam-style practice · 8 draft marks

This original practice task and guidance are not an official examination-board paper or mark scheme.

A student moves a lamp and counts pondweed bubbles for a recorded interval at each position. Describe how to improve validity and reliability, calculate the rate for 42 bubbles in 90 seconds, and explain one possible plateau. (8 draft marks)

Show draft mark guidance
  • Identify lamp distance or light intensity as the changed variable.
  • Identify bubble release per unit time as the measured response.
  • Control temperature or another relevant condition.
  • Keep the same shoot or comparable shoot size and carbon dioxide supply.
  • Repeat readings at each position.
  • Use a mean and report a suitable measure of variation or anomaly.
  • Calculate 42 ÷ 1.5 = 28 bubbles per minute with units.
  • Explain that another factor may become limiting at a plateau.

Exit ticket

Answer without looking back, then check your reasoning.

  1. A shoot releases 45 bubbles in 90 seconds. What is its observed rate per minute?
    Show answer

    45 ÷ 1.5 = 30 bubbles per minute.

  2. Why might increasing light fail to increase the measured rate further?
    Show answer

    Another factor, such as carbon dioxide or temperature, may now limit photosynthesis; the data alone must be checked.

Check your understanding

  • Light provides energy and is not a reactant in the symbol equation.
  • A plateau does not identify which new factor is limiting by itself.
  • Bubble count is an estimate of rate, not an exact oxygen volume.

Retrieve later: Tomorrow, reproduce the rate calculation and identify independent, dependent and three controlled variables without notes.

Next step: Compare carbon dioxide and temperature investigations, then practise evaluating an unfamiliar photosynthesis graph.

Library links: Oak National Academy · Photosynthesis: factors affecting the rate (checked 2026-11-07) · DASKEREL subject library. Oak's applicable post-2022 content licence is OGL v3.0; some source assets have separate third-party rights. No Oak media is embedded here. DASKEREL is not affiliated with Oak.