DASKEREL published · Year 10 · academic review pending

Chemistry GCSE

Original DASKEREL teaching informed by an attributed Oak unit sequence. This resource remains subject to qualified academic review. Check your examination board and tier before using it for exam preparation.

Year 10 · Original DASKEREL extended lesson · Academic review pending

Conservation of mass and balanced reaction calculations

Allow up to 55 minutes for reading, practice and review · Source route: Oak AQA Chemistry Foundation; academic review required

DASKEREL wrote this resource using the Oak National Academy unit sequence as a curriculum reference. It is an extended lesson, not a complete unit or an exam-board-approved course. Academic review remains pending.

You will learn to

  • Balance a simple symbol equation by conserving atoms.
  • Use relative atomic masses and balanced ratios to predict product mass.
  • Explain apparent mass change in an open reaction without rejecting conservation of mass.

Key terms: reactant · product · coefficient · subscript · relative atomic mass · relative formula mass · closed system

Teaching sequence

Check these ideas before you begin:

  • Recognise element symbols, simple formulae and the meaning of a reaction arrow.
  • Multiply and divide whole-number quantities and read the supplied Ar values.
  1. 1. Count atoms · about 8 minutes

    Teach or study: Model the distinction between a coefficient and a subscript before balancing any equation.

    Try: Count Mg and O atoms on both sides of two unbalanced equations.

  2. 2. Balance by conservation · about 12 minutes

    Teach or study: Use particle counters to show 2Mg + O₂ → 2MgO and check both atom totals.

    Try: Balance two equations without changing formula subscripts.

  3. 3. Model mass ratios · about 12 minutes

    Teach or study: Calculate Mr from supplied Ar values, then build the 48:32:80 mass relationship.

    Try: Explain why all three masses must scale by the same factor.

  4. 4. Apply and challenge · about 16 minutes

    Teach or study: Compare a sealed balance with an open vessel and probe which gas crosses the boundary.

    Try: Complete the guided calculation and six independent checks with units.

  5. 5. Assess and retrieve · about 7 minutes

    Teach or study: Use exit responses to locate equation or mass-ratio errors before independent revision.

    Try: Answer both exit prompts and correct a changed-subscript error.

Learn the idea

In a chemical reaction, atoms are rearranged; no atom is created or destroyed in an ordinary chemical change. If all substances are accounted for, total mass of products equals total mass of reactants. A symbol equation records this conservation by showing the same number of atoms of each element on both sides. For example, Mg + O₂ → MgO is not balanced because the left side has two oxygen atoms and the right side has one. Writing 2Mg + O₂ → 2MgO balances two magnesium atoms and two oxygen atoms on both sides. A coefficient changes the number of formula units; it does not change what a compound is.

Subscripts and coefficients do different jobs. The subscript 2 in O₂ belongs to the oxygen molecule. Changing it to O would describe a different particle, so never alter a chemical formula just to balance an equation. A coefficient written before 2MgO means two units of magnesium oxide. Start by counting atoms of each element, choose the smallest whole-number coefficients that balance them, and recount. A balanced equation is necessary before using reaction proportions; the printed formula alone cannot tell you how much of each substance reacts unless the reaction is known.

Relative atomic mass, Ar, is a comparison scale, so it has no gram unit. Relative formula mass, Mr, adds the Ar values for every atom shown in a formula. With exam-supplied Ar(Mg) = 24 and Ar(O) = 16, Mr(MgO) = 24 + 16 = 40. The balanced equation 2Mg + O₂ → 2MgO describes 48 mass parts of magnesium combining with 32 mass parts of oxygen to make 80 mass parts of magnesium oxide. That is a mass ratio, not a claim that every experiment uses exactly 48 grams. Scale all parts by the same factor for a new quantity.

If 6 g of magnesium reacts completely with enough oxygen, the scale factor from 48 g is 6 ÷ 48 = one eighth. Oxygen used is 32 ÷ 8 = 4 g and magnesium oxide formed is 80 ÷ 8 = 10 g. Check the mass sum: 6 + 4 = 10 g. This calculation assumes complete reaction and sufficient oxygen; in a real experiment, oxide may be lost or magnesium may not react fully. When only one reactant quantity is provided, do not invent a yield or assume an unknown second reactant is limiting. State the assumptions that make the simple mass-ratio calculation valid.

An open container can appear to gain or lose mass. Burning magnesium gains measured mass because oxygen from the air joins the solid; if the air was excluded from the initial weighing, the added oxygen was not counted. Heating a carbonate can appear to lose mass as carbon dioxide leaves and is no longer on the balance. A sealed setup that retains all reactants and products should conserve the measured total within uncertainty. A changed balance reading does not disprove conservation; it asks which material crossed the measurement boundary. Always name the gas and direction of movement rather than vaguely saying that mass disappeared.

Worked example

Given Ar(Mg)=24 and Ar(O)=16, predict the mass of MgO made from 12 g of Mg if oxygen is sufficient and reaction is complete.

  1. Balance 2Mg + O₂ → 2MgO and calculate Mr(MgO)=40.
  2. The equation gives 48 mass parts Mg to 80 mass parts MgO.
  3. 12 g is one quarter of 48 g, so product mass is 80 ÷ 4 = 20 g.
  4. The oxygen contribution is 8 g; 12 + 8 = 20 g checks conservation.

The theoretical MgO mass is 20 g under the stated assumptions; it is not a guaranteed experimental yield.

Try together

The same reaction uses 3 g of magnesium completely. Calculate the theoretical oxide mass and oxygen mass used.

  • Find what fraction 3 g is of 48 g in the balanced ratio.
  • Apply that fraction to both 80 g MgO and 32 g oxygen.
Show guided answer

3/48 = 1/16, so MgO = 80/16 = 5 g and oxygen = 32/16 = 2 g. Check 3 + 2 = 5 g.

Practise independently

  1. Balance the equation H₂ + O₂ → H₂O using coefficients only.
    Show answer and reasoning for question 1

    2H₂ + O₂ → 2H₂O. The result has four hydrogen and two oxygen atoms on each side.

  2. Calculate Mr of MgO using Ar(Mg)=24 and Ar(O)=16.
    Show answer and reasoning for question 2

    40. One magnesium atom and one oxygen atom contribute 24 + 16.

  3. Why must the subscript in O₂ stay unchanged while balancing?
    Show answer and reasoning for question 3

    It defines the oxygen molecule. Changing a subscript changes the particle, whereas a coefficient changes its count.

  4. From 2Mg + O₂ → 2MgO, what oxide mass follows from 6 g Mg?
    Show answer and reasoning for question 4

    10 g MgO. Six grams is one eighth of 48 g, so scale 80 g product by one eighth.

  5. A carbonate loses mass on heating in an open crucible. Where may it go?
    Show answer and reasoning for question 5

    Carbon dioxide gas may leave the crucible. The balance then weighs only the remaining solid, not the escaped gas.

  6. State one assumption behind a predicted theoretical product mass.
    Show answer and reasoning for question 6

    The reaction goes to completion with enough of the other reactant. Incomplete reaction or a limiting second reactant would produce less than predicted.

DASKEREL exam-style practice · 8 draft marks

This original practice task and guidance are not an official examination-board paper or mark scheme.

Magnesium is heated in air. Use 2Mg + O₂ → 2MgO and Ar(Mg)=24, Ar(O)=16 to predict MgO from 9.6 g Mg, then explain why an open-container mass may rise. (8 draft marks)

Show draft mark guidance
  • Count or identify the balanced 2:1:2 particle ratio.
  • Calculate 48 mass parts for 2Mg.
  • Calculate 80 mass parts for 2MgO.
  • Compute a scale factor 9.6/48 = 0.2.
  • Calculate 80 × 0.2 = 16 g MgO.
  • Show or infer 6.4 g oxygen contributes to the product.
  • Explain oxygen is taken in from the air.
  • Explain the initial solid weighing did not include that incoming oxygen, while conservation still holds.

Exit ticket

Answer without looking back, then check your reasoning.

  1. Balance Mg + O₂ → MgO without changing a chemical formula.
    Show answer

    2Mg + O₂ → 2MgO.

  2. Why can an open mass measurement increase when magnesium burns?
    Show answer

    Oxygen from the air combines with magnesium and is included in the product mass but not the initially weighed solid.

Check your understanding

  • Balancing a reaction never requires changing the subscript of a valid formula.
  • Mr is a relative number; mass in grams comes from a scaled reaction amount.
  • An open-system balance may omit a gas that enters or leaves.

Retrieve later: Tomorrow, balance the magnesium reaction and reproduce the 48:32:80 mass ratio from supplied Ar values.

Next step: Use balanced equations to compare other reactions, then evaluate mass changes in closed and open systems.

Library links: Oak National Academy · Calculations involving masses (checked 2026-11-07) · DASKEREL subject library. Oak's applicable post-2022 content licence is OGL v3.0; some source assets have separate third-party rights. No Oak media is embedded here. DASKEREL is not affiliated with Oak.